SA56004HD,118【PDF 14/43 页】IC TEMP SENSOR DIGITAL 8SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录46

10页 11页 12页 13页 [14页]15页 16页 17页 18页

SA56004X

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 7 25 February 2013

14 of 43

NXP Semiconductors

SA56004X

Digital temperature sensor with overtemperature alarms

7.9 Interruption logic and functional description

7.9.1 ALERT

output

The ALERT

output is used to signal Alert interruptions from the device to the SMBus or

other system interrupt handler and it is active LOW. Because this is an open-drain output,

a pull-up resistor (typically 10 kW) to V

is required. Several slave devices can share a

common interrupt line on the same SMBus.

The ALERT

function is very versatile and accommodates three separate operating

modes:

" Temperature comparator

" System interrupt based on temperature

" SMBus Alert Response Address (ARA) response.

The ARA and interrupt modes are different only in how the user interacts with the

SA56004X.

At the end of every temperature reading, digital comparators determine if the readings are

above the HIGH or T_CRIT setpoint or below the LOW setpoint register values. If so, the

corresponding bit in the Status register is set. If the ALERT

mask bit 7 of the Configuration

OPEN (D2) causes the ALERT

output pin to be active LOW. An alert will be triggered after

any conversion cycle that finds the temperature is out of the limits defined by the setpoint

registers. In order to trigger an ALERT in all alert modes, the ALERT

mask bit 7 of the

Configuration register must be cleared (not HIGH).

7.9.1.1 ALERT

output in comparator mode

When operating the SA56004X in a system that utilizes an SMBus controller not having

an interrupt, the ALERT

output may be operated as a temperature comparator. In this

mode, when the condition that triggered the ALERT to be asserted is no longer present,

the ALERT

output is released as it goes HIGH. In order to use the ALERT

output as a

temperature comparator, bit D0 (the ALERT configure bit) in the ALERT Mode (AM)

7.9.1.2 ALERT

output in interrupt mode

In the interrupt mode, the ALERT

output is used to provide an interrupt signal that remains

asserted until the interrupt service routine has elapsed. In the interrupt operating mode, a

read of the Status register will set the ALERT

mask bit 7 of the Configuration register if

any of the temperature alarm bits of the Status register is set, with exception of BUSY (D7)

and OPEN (D2). This protocol prevents further ALERT

output triggering until the master

device has reset the ALERT

mask bit at the end of the interrupt service routine. The

Status register bits are cleared only upon a read of the Status register by the serial bus

master (see Figure 5

). In order for the ALERT

output to be used as an interrupt, the

ALERT Configure bit D0 of the ALERT Mode (AM) register must be set LOW (POR

default).

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式